theres two types here, one a little bit bigger than the other, as can be seen in these photos.
Now comes the question, how to mount them, get drive from them, use them!
The two big ones I believe to be 10amp / 12v so about 120w, was thinking of friction drive somehow on the bike maybe mount them facing each other, connect the shafts with a bar of about 4'' in length and us it as the friction roller, one motor would be CW and one CCW, I think they can be run either way, I maybe should open one up and look at the brushes.
Two smaller motors will be off to friction drive the (link) beer buggy...
OK now the controller, its stamped 1020zx speed down motor (?wtf) Model CS38D....
 |
| Wiring has some strange names... |
 |
| Space for an upgrade |
 |
| Space for three of these, and it has the resistor fitted.. |
 |
| R3 fitted, just need a T3 |
 |
| I expected it to be 5v |
No comments:
Post a Comment